Search

In Stock

TE-Econom Bond Refill 5 g

809.00

Compare
SKU:611129AN

Te-Econom Bond is a single-component bonding chemical used with the total-etch procedure to bond enamel and dentin.  

COMPOSITION: 

Consists of HEMA, di- and mono methacrylates, inorganic fillers, initiators, and stabilizers in an alcohol solution. 

INDICATIONS: 

Direct light-curing restorations. 

Weight 0.03 kg
Dimensions 10 × 6 × 5 cm
Brand

Ivoclar Vivadent

Packaging

1 x 5g Bottle

Features

  • One-bottle, one-layer adhesive. 
  • High bond strengths. 
  • Minimal evaporation of the solvent (alcohol). 
  • For direct light-curing restorations. 

 

Specifications

STORAGE TEMPERATURE: 

2–28 °C (36–82 °F) 

INSTRUCTIONS FOR USAGE: 

  • Choose a colour. The flexible and patient-friendly mouth opening OptraGate can be utilised to gain easier access to the treatment field. 
  • Make sure you have enough isolation, preferably with a rubber dam (complete isolation is ensured with, for example, the anatomically shaped OptraDam Plus). 
  • Prepare the cavity according to the adhesive technique’s specifications. 
  • Using a water spray, clean the cavity. 
  • Allow the cavity to air dry. 
  • If necessary, use a pulp protector (calcium hydroxide); only cover sections adjacent to the pulp, then use a pressure-resistant cement (e.g. Vivaglass Liner). 
  • If necessary, place a matrix (such as the selectively thinned OptraMatrix) and an interdental wedge. 
  • Apply Eco-Etch to the enamel and then the dentin, allowing 30 seconds for the enamel and 15 seconds for the dentin to react. After that, rinse the tooth surfaces thoroughly with water spray and dry them with oil-free compressed air. Dentin should not be dehydrated. 
  • Using the supplied applicator brush, apply a generous amount of Te-Econom Bond to enamel and dentin. For 10 seconds, carefully brush the substance into the dentin. Next, use a steady spray of air to evaporate any leftover solvent. Lightcure the glue according to the recommendations for curing time listed below. Ensure that the preparation surface is completely covered. 
  • Apply Te-Econom Flow in 2 mm layers and light cure according to the curing instructions below. Apply Te-Econom Plus in layers of no more than 2 mm and shape the material with a suitable tool (e.g. OptraSculpt). The OptraContact tool can be used to place high-quality proximal contacts selectively. Polymerize each layer separately, as shown in the table below. Hold the light emission window as close to the restorative material’s surface as possible. 
  • Finish the restoration with fine diamonds or appropriate finishers. Check the occlusion after that. Polish with silicone polishers (e.g. OptraPol Next Generation) 

 

Reviews

There are no reviews yet.

Write a review

Your email address will not be published. Required fields are marked *

Vendor Information

  • Store Name: Ivoclar Vivadent
  • Vendor: Ivoclar Vivadent
  • Address: Bramar Inc. 102 Priyadarshini Apartments, 13th Cross,2nd Stage, Indiranagar
    Bangalore
    Karnataka
  • No ratings found yet!
Back to Top
Product has been added to your cart